The Inverex Veyron 2 3.2kW inverter is a popular solar inverter, and like any electronic device, it can encounter errors or faults. Below are some common error causes and troubleshooting steps to resolve them:
Common Error Causes and Solutions
1. Error Code: Low/High Voltage (AC or DC)
•Cause:
•DC input voltage from solar panels is too low or too high.
•AC grid voltage is outside the acceptable range.
Solution:
•Check the solar panel voltage and ensure it is within the inverter's specified range.
•Verify the grid voltage and ensure it matches the inverter's requirements.
•If the grid voltage is unstable, contact your electricity provider.
2. Error Code: Overload
•Cause:
•The inverter is supplying more power than its rated capacity.
•Solution:
•Reduce the load connected to the inverter.
•Ensure the connected load does not exceed the inverter's maximum capacity.
3. Error Code: Over Temperature
•Cause:
•The inverter is overheating due to poor ventilation or high ambient temperature.
•Solution:
•Ensure the inverter is installed in a well-ventilated area.
•Clean any dust or debris blocking the cooling fans.
•Reduce the load to lower the inverter's operating temperature.
4. Error Code: No Grid
•Cause:
•The inverter is not detecting the grid supply.
•Solution:
•Check the grid connection and ensure it is properly connected.
•Verify if there is a power outage in your area.
•Inspect the circuit breakers and fuses for any faults.
5. Error Code: Ground Fault
•Cause:
•There is a leakage current to the ground in the solar panel array.
•Solution:
•Inspect the solar panel wiring for damage or loose connections.
•Check for moisture or dirt on the panels or connectors.
•Use a multimeter to identify the faulty section of the array.
6. Error Code: Communication Failure
•Cause:
•The inverter is not communicating with the monitoring system or other devices.
•solution:
•Check the communication cables (RS485, Wi-Fi, or Ethernet) for proper connections.
•Restart the inverter and monitoring device.
•Update the inverter firmware if necessary.
7. Error Code: Internal Fault
•Cause:
•A hardware or software issue within the inverter.
•Solution:
•Restart the inverter.
•If the error persists, contact Inverex customer support or a certified technician.
•General Troubleshooting Tips
-•Restart the Inverter: Turn off the inverter, wait for 5-10 minutes, and turn it back on.
-••Check the Display: Read the error code on the inverter's display and refer to the user manual for specific instructions.
-•Inspect Wiring: Ensure all DC and AC connections are secure and free from damage.
-••Monitor Solar Panels: Verify that the solar panels are clean and producing the expected voltage.
-•••••Up•Update Firmwae: Check if there are any firmware updates available for your inverter model.
•When to Contact Support
If the error persists after troubleshooting or if you are unsure about the cause, contact Inverex customer support or a certified technician for assistance. Avoid attempting repairs yourself, as this may void the warranty or cause further damage.
For more detailed information, refer to the Inverex Veyron 2 3.2kW User Manual or visit the official Inverex website.
0 Comments